Tabla de contenido
Publicidad
TROUBLESHOOTING CUTTING CONDITIONS
CONDITION
Stringers - Occasional
Blades of Uncut
Grass
Width of Deck
SGB020
Streaking - Strips of
Uncut Grass in Cutting
Path
Width of Deck
SGB018
Streaking - Strips of
Uncut Grass Between
Cutting Paths
Width
Width
of
of
Deck
Deck
SGB019
CAUSE
Low engine RPM
Ground speed too fast
Wet grass
Dull blades, incorrect sharpening
Deck plugged, grass accumulation Clean underside of deck
Belts slipping
Dull, worn blades
Incorrect blade sharpening
Low engine RPM
Belt slipping
Deck plugged, grass accumulation Clean underside of deck
Ground speed too fast
Wet grass
Bent blades
Not enough overlapping
between rows
18
CURE
Run engine at full 3600 RPM
Slow speed to adjust for conditions
Cut grass after it has dried out
Sharpen blades
Adjust belt tensions
Sharpen blades
Sharpen blades
Run engine at full 3600 RPM
Adjust belt tension
Slow speed to adjust for conditions
Cut grass after it has dried out
Replace blades
Increase the overlap of each
pass
Publicidad
Tabla de contenido
