Safety Instructions - IKRA GSL 2500 Instrucciones De Uso

Technical Data
Model
Nominal voltage
Nominal power
Nominal frequency
No-load speed
Max.branch diameter
Weight
Sound pressure level
Service life S6 40%(full load: 4 min., no-load: 6 min.)
Class of protection I; Degree of protection IPX4
Technical and visual changes can be made during the course of the further development and without prior notice.
All information given in these instructions for use are therefore given without guarantee. Legal claims, which are
based on the instructions for use can therefore not be made.
Noise emission information in accordance with
the German Equipment and Product Safety
Act (GPSG) and the EC Machine Directive: the
noise pressure level at the place of work can
exceed 80 dB(A). In such cases the operator
will require noise protection (e.g. wearing of
ear protectors).
Attention noise control! Please observe the re-
gional regulations when starting up the machine
Assembling
1. Turn the motor housing upside down. The two tube
ends to mount the undercarriage on are already pre-
installed to the motor. Put the two included tubes
onto the preinstalled tube ends. Attention: the tubes
to be installed on the right- and left-hand side are
differently shaped and must not be mixed up. Put
the tubes on in such a way that they point outward
after assembly. Then fix the tubes to the preinstalled
tube ends using one of the included screws on each
side (fig.1 + 2).
A - Plug connection
B - Screw
2. Thread the wheel axle through the holes in the legs
and through the tube. (fig.3)
3. Install the wheels on the wheel axle with washers
and nuts (fig.4). Do not tighten the nuts yet.
4. Turn the grinder and place it on a flat surface.
5. Tighten the wheels by putting your weight against
the opposite wheel (fig.5). Screw each wheel ap-
proximately the same amount.
6. Press the wheel caps onto the wheels (fig.6).

Safety instructions

This symbol indicates WARNING.
Personal injury and/or damage to property may re-
sult if the instructions are not followed carefully.
GSL 2500
V~ 230
W 2500
HZ 50
rpm 40
mm 40
kg 23,5
dB(A) 82 (EN 13683)
[K 3,0 dB(A)]
General
• Study the warning stickers on the machine. Replace
damaged or illegible warning stickers.
• Please read through these instructions carefully.
Learn all the controls and the correct use of the
machine.
• The user is responsible for accidents that happen to
other people or their property.
Preparations
• Wear protective gloves, protective glasses and
hearing protectors. Avoid loose clothing.
• Always stand steadily and in balance. Do not stretch
towards the machine.
• During use, the machine should be flat and on a firm
surface.
• Ensure that all screws and nuts are properly tight-
ened before use.
• Only use the machine in dry conditions and never
outdoors when it is raining.
• Never use the machine with damaged safety de-
vices or without protection.
Using the machine
• Hard objects such as stones, bottle, cans or pieces
of metal must not be fed into the feeding hopper.
This can cause damage to the machine.
• If the machine becomes blocked, stop motor and
disconnect the plug. Pull out any objects and check
for damage.
• Do not tug on the connection cable. Do not hold the
cable taught. This can cause damage in the plugs
or in the cable's insulation. Such damage is invisible
but can be dangerous.
• Always keep the connection cable away from the
machine. Disconnect the plug from the electric
socket and check the cable regularly for signs of
damage or ageing. Do no use the machine with a
damaged connection cable.
GB-2