Additional Safety Instructions For Hammer Drills - BLACK&DECKER HP120K Manual De Instrucciones

ENGLISH
V...............................Volts
A.............................. Amperes
Hz............................ Hertz
W..............................Watts
min...........................minutes
...........................Alternating current
...........................Direct current
n ............................. No load speed
0
ADDITIONAL SAFETY INSTRUCTIONS FOR
BATTERIES
• Never attempt to open for any reason.
• Do not expose to water.
• Do not store in locations where the temperature may exceed 40 °C.
• Charge only at ambient temperatures between 4 °C and 40 °C. Charge only using the charger provided with the tool (see
technical data).
• Before charging, make sure that the battery is dry and clean.
• Use only the correct type of battery for the tool (see technical data).
• When disposing of batteries, follow the instructions given in the section "Protecting the environment".
• Under extreme conditions, battery leakage may occur. When you notice liquid on the battery, proceed as follows:
• Carefully wipe the liquid off using a cloth. Avoid skin contact.
• In case of skin or eye contact, follow the instructions below.
WARNING:
The battery fluid, a 25-30% solution of potassium hydroxide, can be harmful. In case of skin contact,
immediately rinse with water. Neutralize with a mild acid such as lemon juice or vinegar. In case of eye contact, rinse
abundantly with clean water for at least 10 minutes. Consult a physician.
DANGER:
Fire hazard! Avoid short-circuiting the contacts of a detached battery (e.g. when storing the battery in a
toolbox). Do not incinerate the battery. Do not attempt to charge damaged batteries.
CHARGERS
• Use your Black & Decker charger only to charge batteries of the type supplied with your tool. Other batteries could burst,
causing personal injury and damage.
• Never attempt to charge non-rechargeable batteries.
• Have defective cords replaced immediately.
• Do not expose to water.
• Do not open the charger.
• Do not probe the charger.
• The charger is intended for indoor use only.
ADDITIONAL SAFETY INSTRUCTIONS
• Before drilling into walls, floors or ceilings, check for the location of wiring and pipes.
• Avoid touching the tip of a drill bit just after drilling, as it may be hot.
BATTERIES AND CHARGERS
FOR HAMMER DRILLS
...........................Class II Construction
...........................Earthing terminal
...........................Safety alert symbol
.../min...................... Revolutions or reciprocations
per minute
mW...........................milivatios
nm........................... Longitud de ondas en nanómetros
II...............................Láser de Clase II
20