Measurement Operation; Dc Voltage Measurement - Minipa MT-1400 Manual De Instrucciones

Key
- Press HOLD once to enter HOLD mode.
HOLD
- Press HOLD again to leave HOLD mode.
Key
- When Hold mode is activated, H is displayed and the
present value is frozen.
- Press BLUE key once to turn on the display backlight.
BLUE
- Press BLUE key again to turn off the display backlight.
Key
- The display backlight will NOT turn off until BLUE key is
pressed.

8) MEASUREMENT OPERATION

A. DC Voltage Measurement
Warning
To avoid harms to you or damages to the Meter from electric shock,
please do not attempt to measure voltages higher than 500V although
readings may be obtained.
The DC Voltage ranges are: 200mV,
2000mV, 20V, 200V and 500V. To
measure DC voltage, connect the
Meter as follows:
1. Insert the red test lead into the
VΩmA°C°F terminal and the black
test lead into the COM terminal.
2. Set the rotary switch to an appro-
priate measurement position V
3. C o n n e c t
ds over the object being me-
asured. The measured value
shows on the display.
Executed Operation
t h e t e s t
.
l e a -
6
Figure 2