Publicidad
Idiomas disponibles
Idiomas disponibles
To start cooking
1.
Touch the ON/OFF (5) for 3 seconds. After power on, the buzzer beeps once, all
displays show "–"or "– –", indicating that the induction hob has entered the state
of standby mode.
2.
Place a suitable cookware on the cooking zone that you wish to use. Make sure
the bottom of the cookware and the surface of the cooking zone are clean and dry.
3.
Set a power level between 1 and 9 by sliding along the "slider" (3) key, or just
touch any point of the "slider" (3).
4.
If you don't choose a power setting within 20 seconds, the induction hob will
automatically switch off. You will need to start again at step 1.
•
You can modify the power setting at any time during cooking.
If the display flashes alternately with the power setting
This means that:
• The cookware is not placed on the correct cooking zone or,
• The cookware is not suitable for induction cooking or,
• The cookware is too small or not properly centred on the cooking zone.
No heating takes place unless there is a suitable cookware on the cooking zone.
The display will automatically turn off after 1 minute if no suitable cookware is placed
on it.
When you have finished cooking
1.
Touch the power level slider (3) to decrease the power to "0" level.
2.
Beware of hot surfaces.
Residual heat indicator
After switching off the cooking zone, the corresponding power display will indicate "H"
until the temperature in the zone has dropped below the critical level.
EN
Publicidad
