Stopping The Engine; Adjusting Idle Speed - Ryobi RY3714 Manual Del Operador

Ocultar thumbs Ver también para RY3714:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STOPPING THE ENGINE

See Figures 11 - 12.
Release the throttle trigger and let the engine
return to idle. To stop the engine, move the on/
stop switch to the STOP (
the chain saw on the ground when the chain is still
moving. For additional safety, set the chain brake
when the saw is not in use.
In the event that the on/stop switch will not stop the
saw, pull the choke knob out to the fully extended
position (FULL CHOKE /
brake to stop the engine. If the on/stop switch will
not stop the saw when set to the STOP position,
have the on/stop switch repaired before using the
chain saw again to prevent unsafe conditions or
serious injury.
NOTE: When you are finished using the saw,
always relieve tank pressure by loosening, then
retightening, the chain oil and fuel mix caps. Allow
the engine to cool before storing.

ADJUSTING IDLE SPEED

See Figure 13.
WARNING:
The chain will move around the guide bar when
adjusting the idle speed. Wear all protective
clothing and keep all bystanders, children, and
pets at least 50 ft. away. Make adjustments
with the unit supported on a stable surface so
that the chain/guide bar does not contact the
ground or any object. Keep all parts of your
body away from the chain/guide bar and muf-
fler. Failure to follow these instructions could
result in serious personal injury.
 If the engine starts, runs, and accelerates,
but will not idle, turn the idle speed screw "T"
clockwise to increase idle speed.
 If the chain turns at idle, turn the idle speed
screw "T" counterclockwise to reduce the
idle RPM and stop the chain movement. If the
saw chain still moves at idle speed, contact
a qualified service center for adjustment and
discontinue use until the repair is made.
OPERATION
) position. Do not put
) and engage chain
Page 16 — English
ON/STOP SWITCH IN
THE STOP POSITION
Fig. 11
BRAKE POSITION
Fig. 12
IDLE SPEED
SCREW "T"
Fig. 13

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ry3716

Tabla de contenido