If you must replace a grinding wheel, be sure
to obtain one with a safe rated speed greater
than the "no load speed" rpm marked on the
data plate of the grinder.
To replace the grinding wheel, remove the
wheel cover by loosening the screws. Loosen
the wheel nut in a clockwise direction for the
left side and a counterclockwise direction for
the right side.
Remove the outer flange and grinding wheel.
To install a new grinding wheel, reverse the
above procedure. Be sure the grinding wheel
and outer flange are properly seated on the
spindle shaft.
MAINTENANCE
WARNING: when servicing, use only iden-
tical replacement parts. Use of any other part
may create a hazard or cause product damage.
GENERAL
Keep the bench grinder clean. Remove dust
from working parts and beneath the grinder
frequently. Make sure the bench grinder oper-
ates properly. Check screws, nuts, and bolts for
tightness.
Servicing requires extreme care and knowl-
edge and should be performed only by a quali-
fied service technician. For service we suggest
you return the tool to your nearest authorized
service center for repair. When servicing, use
only identical replacement parts.
E N G L I S H •
TECHNICAL DATA
VOLTAGE-FREQUENCY
SPEED
WHEEL CAPACITY
SPINDLE DIAMETER
POWER
WEIGHT
U s e r's m a nu al
120 V ~ 60 Hz
2 950 r/min
5" (127 mm)
1/2" (12,7 mm)
150 W
5,9 kg (16 lb)
13