Hitachi 50HAK6152 Manual De Instrucciones página 14

Standby Button
Press and hold the Standby button on the remote
control. Power off dialogue will appear on the screen.
Highlight OK and press the OK button. The TV will
switch into standby mode. Press briefly and release
to switch the TV into quick standby mode or to switch
on the TV when in quick standby or standby mode.
Inserting the Batteries into the Remote
Remove the screw that secure the battery compartment
cover on the back side of the remote control first. Lift
the cover gently. Insert two 1.5V - size AAA batteries.
Make sure the (+) and (-) signs match (observe correct
polarity). Do not mix old and new batteries. Replace
only with same or equivalent type. Place the cover back
on. Then screw the cover back on again.
To pair remote with the TV
When TV is turned on for the first time, a search for
accessories will be performed before the initial setup
starts. You will need to pair your remote control with
your TV at this point.
Press and hold the Source button on the remote for
about 5 seconds, the LED on the remote will light up.
Then release the Source button, the LED will start
to blink. That means the remote is in pairing mode.
Now you will wait the TV to find your remote. Select the
name of your remote and press OK when it appears
on the TV screen.
When the paring process was successful, the LED
on the remote will go off. If the pairing process fails
the remote will enter to sleep mode after 30 seconds.
English - 10 -