Part Descriptions; Putting Into Service; Electrical Connection - HAEGER Halo 1200 Plus Instrucciones De Uso

The appliance must not be positioned directly underneath a fixed power
–
point.
Do not cover the appliance while it is functioning to avoid overheating
with the attendant risk of fire.
CAUTION: Do not use the heater with a programmer, timer or any other device
that switches the heater on automatically.
WARNING: This heater is not equipped with a device to control the room
temperature. Do not use this heater in small rooms when they are occupied by
persons not capable of leaving the room on their own, unless constant
supervision is provided.

Part descriptions

1 - Power switch 0 – 1
3 - Lower heating lamp switch
5 – Upper lid
7 – Reflector
9 – Grille
11 – Butterfly nuts
13 - Power cord guide

Putting into Service

Electrical Connection

1. Connect the device to a duly installed 230V/50Hz protective contact socket.
Check that the outlet has at least a 10 AMPERE current carrying capacity.
2. Before inserting the plug into the socket. Make sure that the mains voltage
to be used matches that of the device. You can find this information on the
nameplate.
How to use
Assembly
Assemble the body frame and the base plate together as the following
sequences:
1. Remove the butterfly nuts from the lower part of the body frame.
2. Insert the power cord through the slot placed in the middle part of the
basement and then assemble the body frame to the base plate.
3. Secure the body frame to the base plate by means of the two butterfly nuts
previously removed. Insert the power cord through the suitable slots and
then fix it by the clamp.
Instructions for use
2 - Upper heating lamp switch
4 - Oscillation switch
6 – Halogen heating lamp
8 – Honey comb grille
10 – Base
12 – Safety switch
English
3