Cleaning And Storage - JOCCA 9026 Manual De Instrucciones

12-P
should use it under adult supervision
-Before connecting the device to the mains or the car connec-
tion make sure the cable and plug are in perfect condition, also
check that the voltage on the device is valid for electrical insta-
llation. Make sure the selector AC / DC is placed to the desired
position.
-If you detect that the power cable or plug are damaged, do not
use the device and do not try to replace the cable. Go directly
to the authorized service JOCCA where it will be replaced pro-
perly.
-The power cable can not be in contact or nearby the hot parts
of the device.
-Do not immerse the device into the water or other liquid.
-Do not pull the electric cable to disconnect the device from the
mains or the car connection, always pull the plug.
-If your appliance has been dropped or has fallen into the water
or other liquid, do not use it and do not try to repair it. Bring the
device to the authorized technical service JOCCA.
-Do not use the device with wet hands and bare feet.
-Use the device on a flat, smooth and horizontal surface, leaving
enough space above and at sides of the device for proper air
circulation.
-We do not recommend to use the adapters, plugs and / or ex-
tension cords.
-It does not require assembling by a technician. Use the device
only in vertical position
-Make sure the ventilation outputs are not obstructed.
-The fridge does not include a freezer, so it is not designed to
freeze food.
INSTRUCTIONS FOR USE
-The device is equipped with two electric cables: AC (220-240V)
and DC (12V).
-When using the device in a car, insert the 12V cable into the
12V outlet located on the side of the device and turn the ad-
justment selector to DC position, connect the other end of the
cable to the entrance of the cigarette lighter.
-If you use the device at home, connect the cable AC 220-240V
to the outlet AC 220-240V located on the side of the device and
turn the adjustment selector to AC position, connect the other
end of the cable into the power outlet in your home.
-Before using the device for the first time, clean it with a damp
cloth and let it dry.
-Select the desired function with the temperature selector: cool
(Cool) or heat (Warm).
-The cooling function is indicated by the green pilot light, the heat
function - by the red pilot light.
-If you use the device in the heating mode, the red pilot light
will be switched off automatically when it reaches the maximum
temperature and will be switched on again to rewarm
-Unplug the device from the electrical outlet after each use.

CLEANING AND STORAGE

-Before cleaning make sure the device is disconnected from the
mains.
-Empty the device before cleaning it.
-Clean the device inside with a solution of water and bicarbonate
of soda. Then rinse it with clean water.
-Clean the device regulary.
-Do not use abrasive cleaners or products that may damage the
device.
-NEVER IMMERSE THE DEVICE IN THE WATER OR OTHER LI-
QUID.
E-13