Introduction; Connections, Operating And Display Elements - Palmer WTP B40 Manual De Usuario

INTRODUCTION

The regulated Palmer Universal power supply unit for the Palmer PEDALBAY 40 offers 8 low-voltage outputs
for powering guitar and bass guitar effects devices. Built into the pedalboard, it offers convenient and
organised wiring, and looks tidy. Even during transport, effects devices can remain wired thanks to the
special metal guard strip that protects connected low-voltage wires against damage and unintended
removal. Four attachment points in the metal section are positioned to facilitate permanent and secure
attachment of the wires with cable ties. A sufficient number of low-voltage wires with standard 2.1 x 5.5 mm
coaxial power connectors are included.
PANTONE Warm Gray 8C

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

INPUT
1
Low-voltage connector for supplying power to the power supply unit (12 V DC / 2 A, outside: positive).
Please use only the provided power adapter, to protect the power supply unit from damage and to ensure
sufficient and safe power supply for all connected effects devices.
OUTPUT
2
Low-voltage connector for forwarding the power supply connected to the INPUT socket.
POWER
3
Device ON/OFF button.
POWER LED
4
PANTONE Warm Gray 8C
The POWER LED lights up as soon as the device is correctly connected to the power supply and
switched on.
5
6
DC OUTPUTS
5
Six low-voltage connectors, each with a 9 V DC and maximum 300 mA current for connecting effects devices
with the corresponding load values (9 V DC / outside: positive / up to 300 mA).
2
1
3
4
5