Display Indicators - Hama Premium Instrucciones De Uso

5. Starting up/entering the electricity price
(euro/kWh)
Note
• If the energy cost meter cannot be started, then
press the reset button (4) for a few seconds.
• The rechargeable battery is charged during operation.
• The internal rechargeable battery will discharge if
the timer switch is not used for longer periods of
time. Plug the energy cost meter into a mains plug
for approx. 24 hours every 3 months to charge the
internal rechargeable battery.
• Press and hold the cost button (3) for approx.
3 seconds in order to enter your current energy price
per kilowatt-hour. The display flashes Cost/KWh.
• Use the Function button (2) to select the digit you
would like to enter.
• Set the desired value using the Up (5) and Down (6)
buttons.
• Press the cost button (3) to save the entered value and
leave input mode.
6. Measurement
Note
• Precise measurement results even for small appliances.
• The voltage and power draw of the connected
devices may not exceed 230 V and 3680 W.
• Note the information specified on the nameplate(s)
of the connected device(s).
• If you connect an electrical appliance that draws more
than 3680 W, then the display shows OVERLOAD.
• It is advisable to measure the power consumption
of a device for an extended period of time and then
calculate its annual consumption.
• Plug the energy cost meter into a conventional mains
socket.
• Plug the electrical device to be measured or its mains
plug into the socket on the energy cost meter. The
consumption measurement commences automatically.
• Press the Function button (2) to change the display
mode (see section 7).
• Unplug the electrical device from the energy cost
meter or the energy cost meter from the mains socket
to end the measurement.

7. Display indicators

• You can change which information is shown in the
display by pressing the Function button (2).
• Pressing the Cost button (3) takes you directly to a
display of the currently configured electricity tariff.
(7. Display)
The following display modes are available:
1. Display
Measured time Consumption „W"
2. Display
Measured time Power „KWh"
3. Display
Measured time Voltage „V"
4. Display
Measured time Amperage „A"
5. Display
Minimum con-
Measured time
sumption „W"
6. Display
Maximum con-
Measured time
sumption „W"
7. Display
Measured time
Note
After a period of 24 hours, the time in the second
display reverts to 00:00 and starts over. At the same
time, the day indicator increases by one.
Energy costs
„COST"
„DAY"
Frequency „Hz"
"Power Factor"
Lo
Hi
Price per
kilowatt hour
„COST/KWh"
3