Important Safety Measures - i-tec CHRGER-C112W Manual De Instrucciones

Quick Start / Universal Charger USB-C 112W
USING THE POWER ADAPTER
Connecting the universal adapter to the device:
1. Connect the adapter to the 110/230V mains, using the supplied
cable.
2. Connect the USB-C cable to the USB-C port on the power adapter.
3. Connect the USB-C cable to the charging USB-C port on the device.
4. The LED indicator will illuminate and charging will begin.
Note: When powering mobile phones and similar devices without
a USB-C connector, you can use the USB-A port on the adapter. Power
over the USB-A port is provided on the assumption that the given
device supports it.

IMPORTANT SAFETY MEASURES:

• Do not pull the power supply cable from the mains socket by
pulling the cable.
• Do not connect to or pull the power cord from the socket with wet
hands.
• Do not connect the adapter if it is damaged (e.g. short circuit,
burnt PVC case).
• Immediately disconnect the adapter from the mains socket
should you smell burning.
• Do not disassemble this device or make modifications, as this
could case a fire risk, injury or damage to personal property.
Entrust all repairs to the manufacturer, i-tec Technologies s.r.o..
• Do not expose the adapter to direct sunlight, place it on heating
elements, or on any other heat. Do not cover it with paper or any
other material that could influence air circulation.
• Do not use the adapter in an environment with a temperature
below 0°C or higher than 40°C. Use in ventilated areas only.
• Do not place the adapter on heat-sensitive surfaces.
• Make sure your power supply provides the required voltage (V)
and frequency (Hz).
• Do not use the adapter with damaged supply cord, cable or fuses.
• Keep away from children.
• Ensure the output voltage of the power adapter is suitable for
your device.
EN
7