Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Installation Instructions
Free-Standing and Front
Control Electric Ranges
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT —
Save these
instructions for local inspector's use.
• IMPORTANT —
Observe all
governing codes and ordinances.
Note to Installer – Be sure to leave these
instructions with Consumer.
FOR YOUR SAFETY:
WARNING
Tip-Over Hazard
• A child or adult can tip the range and be killed.
• Install the anti-tip bracket to the wall or floor.
• Engage the range to the anti-tip bracket by sliding the
range back such that the foot is engaged.
• Re-engage the anti-tip bracket if the range is moved.
• Failure to do so can result in death or serious burns
to children or adults.
If you did not receive an anti-tip bracket with your
purchase, call 1.800.626.8774 to receive one at no
cost. (In Canada, call 1.800.561.3344.) For installation
instructions of the bracket,
visit: www.GEAppliances.com.
(In Canada, www.GEAppliances.ca.)
MATERIALS YOU MAY NEED
Squeeze Connector
(UL Listed 40 AMP)
(For Conduit
4-Wire Cord 4' long OR
Installations Only)
3-Wire Cord 4' long
1
REMOVE PACKAGING MATERIALS:
materials could result in damage to the appliance. Remove all packing parts from oven,
racks, heating elements and drawer. Also, remove protective film and labels on the outer
door, cooktop and control panel.
Note to Consumer – Keep these
instructions for future reference.
Skill level – Installation of this appliance
requires basic mechanical skills and
advanced electrical skills.
Proper installation is the responsibility of the
installer.
Product failure due to improper installation
is not covered under Warranty.
Anti-Tip Bracket
Kit Included
WARNING
Before beginning
the installation, switch power off at
service panel and lock the service
disconnecting means to prevent power
from being switched on accidentally.
When the service disconnecting
means cannot be locked, securely
fasten a prominent warning device,
such as a tag, to the service panel.
TOOLS YOU WILL NEED
Drill with 1/8" Bit
Tape Measure
Safety Glasses
Pliers
Adjustable Wrench
1/4" Nut Driver
Level
Tin Snips
Failure to remove packaging
2
PREPARE THE OPENING (FOR INDOOR USE ONLY)
See illustrations for all rough-in and spacing dimensions. The range may be placed with 0"
clearance (flush) at the back wall and side walls of the cabinet.
2
" (3
1 2
1 4
double ovens)
Unit will not mount flush
to counter when heights
are less than 36".
29
"
7 8
47"
Acceptable electrical
(36" to
outlet area. Orient
cooktop
height)
electrical receptacle
so the length is
NOTE:
Rear wall
parallel to floor.
to front
Use a flush mount
of door
glass.
25
"
1 2
outlet for double
(25
3 4
" on
oven models.
47
5 8
"
double oven)
(45
" on
1 8
double oven)
REAR CONTROL
NOTE: Use a 4' power cord to prevent interference
with the storage drawer. Power cords 4
' to 6' long
1 2
may have to be dressed to allow for proper drawer
closing.
MINIMUM DIMENSIONS BETWEEN COOKTOP,
WALLS AND ABOVE THE COOKTOP:
A. Make sure the wall covering, countertop, flooring
and cabinets around the range can withstand
the heat (up to 200°F) generated by the range.
B. Allow 30" minimum clearance between surface
units and bottom of unprotected wood or metal
cabinet, or allow a 24" minimum when bottom
of wood or metal cabinet is protected by no
less than 1/4" thick flame retardant millboard
covered with not less than No 28 MSG sheet
metal, (.015"), .015" thick stainless steel, .024"
aluminum or .020" copper.
C. This appliance has been approved for 0" spacing to adjacent surfaces above the cooktop.
However, a 6" minimum spacing to surfaces less than 15" above the cooktop and adjacent
cabinet is recommended to reduce exposure to steam, grease splatter and heat.
To reduce the risk of burns or fire when reaching over hot surface elements, cabinet storage
space above the cooktop should be avoided. If cabinet storage space is to be provided above
the cooktop, the risk can be reduced by installing a range hood that projects at least 5" beyond
the front of the cabinets. Cabinets installed above the cooktop must be no deeper than 16".
" on
30"
2
" (3
" on
1 2
1 4
25"
double ovens)
(23" on
double
ovens)
(7
" on
3 4
double
ovens)
29
6
"
1 2
4" (3"
29
7 8
"
on double
ovens)
NOTE:
Rear wall
to front
of door
glass.
FRONT CONTROL
B
NOTE C
A
A
"
7 8
36
"
5 8
36"
25
"
3 4
45
1 8
" (47
7 8
" on
single oven)
C
Both
Sides

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Cafe CHS900M2NS5

  • Página 1 Installation Instructions PREPARE THE OPENING (FOR INDOOR USE ONLY) Free-Standing and Front See illustrations for all rough-in and spacing dimensions. The range may be placed with 0” clearance (flush) at the back wall and side walls of the cabinet. Control Electric Ranges ”...
  • Página 2: Electrical Requirements

    ELECTRICAL REQUIREMENTS POWER CORD AND CONDUIT INSTALLATION A. Remove wire cover (on the back of range) by removing screws using a 1/4” nut driver. You can WARNING This appliance must be properly grounded. access the terminal block by either removing a terminal block cover (on some models) or the wire cover.
  • Página 3 3-WIRE INSTALLATION 4-WIRE INSTALLATION WARNING WARNING The neutral or ground wire of the power cord must be connected to the The neutral wire of neutral terminal located in the center of the terminal block and the ground strap must connect the Before–Power Cord and Conduit the supply circuit must be connected to the neutral terminal to the ground plate.
  • Página 4: Anti-Tip Device Installation

    ANTI-TIP DEVICE INSTALLATION LEVEL THE RANGE (CONT.) To reduce the risk of MODELS WITH DOUBLE OVEN WARNING tipping the range, the range must be secured by A. Plug in the unit. Tip-Over Hazard a properly installed anti-tip B. Measure the height of your countertop at the rear of the opening (X). •...
  • Página 5: Antes De Comenzar

    Instrucciones de instalación CÓMO PREPARAR LA ABERTURA (PARA USO EN EL INTERIOR SOLAMENTE) Cocinas Eléctricas sin Pedestal y Ver ilustraciones con todas las dimensiones de empotrado y de espacio. La cocina puede ubicarse con un espacio de 0” (alineado) sobre la pared trasera y las paredes laterales del gabinete. Control Frontal ”...
  • Página 6: Requerimientos Eléctricos

    REQUERIMIENTOS ELÉCTRICOS INSTALACIÓN DE CABLE DE ENERGÍA Y DE PASACABLES A. Quite la tapa del cable (en la parte trasera de la cocina) quitando tornillos mediante una ADVERTENCIA Esta unidad debe contar con una adecuada conexión a tierra. llave de tuercas de 1/4”. Usted puede acceder el bloque terminal quitando la tapa del bloque terminal (en algunos modelos) o la tapa de los cables.
  • Página 7: Instalación De Tres (3) Alambres

    INSTALACIÓN DE TRES (3) ALAMBRES INSTALACIÓN DE 4 HILOS ADVERTENCIA ADVERTENCIA El cable neutral o a tierra del cable de energía debe estar El cable neutral Antes – Cable de energía y conducto conectado a la terminal neutral ubicada en el centro del bloque terminal y la cinta de conexión del circuito de suministro debe estar conectado a tierra debe conectar la terminal neutral a la placa de conexión a tierra.
  • Página 8: Lista De Control Final De La Instalación

    INSTALACIÓN DE DISPOSITIVO ANTI-VOLCADURAS NIVELE LA COCINA (CONT.) Para reducir el riesgo de ADVERTENCIA MODELOS CON CALENTADORES HORNO DOBLE volcar la cocina, ésta debe sujetarse mediante un Riesgo de Caída A. Enchufe la unidad. • Un niño o adulto pueden volcar la cocina y morir. soporte anti-volcaduras con B.

Tabla de contenido