Parts Name Of Remote Controller - Toshiba MMU-AP0091H Manual Del Propietário

PARTS NAME OF REMOTE CONTROLLER

Display section
In the display example, all indicators are displayed for the explanation.
In reality only, the selected contents are indicated.
• When turning on the leak breaker at the first time, [SET DATA] flashes on
the display part of the remote controller. While this display is flashing, the
model is being automatically confirmed. Accordingly, wait for a while after
[SET DATA] display has disappeared, and then use the remote controller.
1
2
4
7
1
SET DATA display
Displayed during setup of the timer.
2
Operation mode select display
The selected operation mode is displayed.
3
CHECK display
Displayed while the protective device works or
a trouble occurs.
4
Timer time display
Time of the timer is displayed.
(When a trouble occurs, the check code is
displayed.)
5
Timer SETIN setup display
When pushing the Timer SETIN button, the
display of the timer is selected in order of
→ [OFF] repeat OFF timer →
[OFF]
→ No display.
[ON]
6
Filter display
If "FILTER " is displayed, clean the air
filter.
7
TEST run display
Displayed during a test run.
8
Flap position display
(for 4-Way Air Discharge Cassette Type
and Under Ceiling Type model only)
Displays flap position.
9
SWING display
Displayed during up/down movement of the
flap.
10
Set up temperature display
The selected set up temp. is displayed.
11
Remote controller sensor display
Displayed while the sensor of the remote
controller is used.
8
3
SET DATA
5
SETTING
6
CODE No.
UNIT No.
TEST
R.C. No.
12
PRE-HEAT display
Displayed when the heating operation starts or
defrost operation is carried out.
While this indication is displayed, the indoor fan
stops or the mode enters in LOW.
13
Operation ready display
Displayed when cooling or heating operation is
impossible because the outdoor temperature goes
out of the operable range.
14
No function display
Displayed if there is no function even if the button is
pushed.
15
Air volume select display
The selected air volume mode is displayed.
(AUTO)
(MED.)
In the Concealed Duct High Static Pressure type
models, [HIGH] only is
displayed for the air speed.
16
Mode select control display
Displayed when pushing "Operation mode select"
button while the operation mode is fixed to heating
or cooling by the system manager of the air condi-
tioner.
17
Central control display
Displayed when using the remote controller together
with the central control remote controller, etc.
If Remote controller is prohibited at the
centralcontrol side,
,
the change is not accepted.
(The contents available to be set up on the remote
controller differ according to the central control
mode. For details, refer to Owner's Manual of the
central control remote controller.)
6
CODE No.
SET DATA
UNIT No.
SETTING TEST
R.C. No.
UNIT
SET CL
16
17
9
10
11
12
13
14
15
(HIGH)
(LOW)
flashes when operating
, / buttons and
Display
section
Operation
section