Monogram ZDT165SILII Manual Del Propietário página 13

Problem
Detergent left in
dispenser cups
Black or gray marks
on dishes
Dishes don't dry
Control panel
responded to inputs
but dishwasher never
filled with water
Stained tub interior
Dishwasher won't run
Control panel lights
go off when you're
setting controls
Water standing in the
bottom of the tub
Water won't pump out
of the tub
Possible Cause
Dishes or utensils are blocking
the detergent cup
Aluminum utensils have
rubbed against dishes
Door not opened immediately
after CLEAN light came on
Low inlet water temperature
Rinse agent dispenser is
empty
Door may not be completely
closed
Water valve may be turned off
An overall yellow or brown
film can be caused by iron
deposits in water
White film on inside surface—
hard water minerals
Fuse is blown or circuit
breaker is tripped
Power is turned off
Control panel is locked
Reboot your control
Time too long between
touching of selected buttons
Air gap is clogged
High drain loop or air gap not
installed
Drain is clogged
Troubleshooting Tips
Dishwasher
What To Do
Reposition the dishes, so the water from the lower spray arm
can flush the detergent cup. See the Loading section.
Reposition the tall utensils or heavy silverware that may
be keeping the dispenser cup door from opening. See the
Loading section.
Remove marks with a mild, abrasive cleaner.
For proper drying, the dishwasher door must be opened
immediately after the CLEAN light comes on.
Make sure inlet water temperature is at least 120°F.
Use WASH TEMP BOOST.
Select a higher cycle, such as HEAVY.
Check the rinse agent dispenser and fill as required.
Make sure the door is firmly closed.
Make sure water valve (usually located under the sink) is
turned on.
A special filter in the water supply line is the only way to correct
this problem. Contact a water softener company.
We recommend Finish Jet-Dry
®
water mineral deposits from forming.
Run dishwasher with citric acid to remove mineral deposits.
Citric acid (Part number: WD35X151) can be ordered
through Monogram. See back page for ordering information.
Alternatively, purchase Finish
follow the directions on the label.
Replace fuse or reset circuit breaker. Remove any other
appliances from the circuit.
In some installations, the power to the dishwasher is provided
through a wall switch, often located next to the disposer switch.
Make sure it is on.
Unlock control panel. See the Getting started section.
Turn off power to the dishwasher (at circuit breaker or wall
switch) for 30 seconds, then turn back on.
Each button must be touched within 30 seconds of the others.
To relight, touch any button again or open the door and unlock.
Clean the air gap. See the Care and Cleaning section.
Refer to the Installation Instructions for proper drain line
installation.
If you have an air gap, clean it. See the Care and Cleaning
section.
If the dishwasher drains into a disposer, run disposer clear.
Check to see if your kitchen sink is draining well. If not, you
may need a plumber.
Rinse Aid to help prevent hard
®
Dishwasher Cleaner and
®
13