Publicidad
Getting Connected and Installing Drivers (Windows)
Windows Me users
1
With the UA-20 disconnected, start up Windows.
Disconnect all USB cables except for a USB keyboard and USB
mouse (if used).
2
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to
exit it as well.
3
Place the UA-20's ADVANCE (mode select) switch
in the OFF position.
4
Use a USB cable to connect the UA-20 to your
computer.
fig.05-23e_30
5
Windows will detect the
UA-20, and the "Add
New Hardware Wizard"
dialog box will appear.
Make sure that Automatic
search for a better driver (Recommended) is selected, and
click [Next].
6
Driver detection will begin.
7
When the driver has been found, driver installation
will begin.
fig.05-24e_30
8
Once the driver has been
installed, a dialog box
will inform you of this.
Click [Finish].
32
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
connecting a USB connector is
required before the unit will
operate normally.
Depending on your system, a
certain amount of time may be
required for the device to be
detected after the driver has
been installed.
Publicidad
Solución de problemas
