Getting To Know Your Kettle; Before Using Your Kettle; Using Your Kettle - Bella 13822 Manual De Instrucciones

Getting to Know Your Kettle

Product may vary slightly from illustration
Figure 1
Lid Opening
Handle
Lid
Spout
Spout Filter
(not shown)
Glass Body
Handle Cover
Handle
ON/OFF Switch
Lamp Cover
Power Base

Before Using Your Kettle

If you are using the kettle for the first time, it is recommended that you clean your kettle before use by boiling
a full kettle of water twice and then discarding the water.
NOTE: The max capacity of kettle is about 7 cups.

Using Your Kettle

1. To fill the kettle, remove it from the power base and open the lid by pulling it backwards and lifting
the lid handle. Fill with the desired amount of water. Alternatively, the kettle may be filled through
the spout. The water level should not exceed max marks or sit below MIN-MAX. Too little water will result
in the kettle switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout when boiling.
Ensure that the lid is firmly in place before plugging into the power outlet.
2. Position the kettle on the power base.
3. Connect the plug into a power outlet. Press the switch down, the indicator light will turn on.
Then the kettle will start to boil the water. The kettle will switch off automatically once the water
has boiled.
NOTE: Ensure that the switch is free of obstructions and that the lid is firmly closed. The kettle will
not turn off if the switch is constrained or if the lid is opened.
4. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your kettle as boiling water will scald.
5. The kettle will not re-boil until the switch is pressed again. The kettle may be stored on the power base
when not in use.
4
OFF
ON