Additional Safety Instructions - Collomix CMG 1700 Manual De Servicio

Additional safety instructions

► Wear protective goggles and
hearing protection.
Do not touch the diamond cup disk until it has
►
cooled down. Diamond cup disks become very
hot during operation.
► Use a dust extractor when grinding stone. The
dust extractor must be certified for stone dust
extraction. The use of these devices reduces
the hazards of dust.
► Do not grind any materials or workpieces con-
taining asbestos.
► Grip the power tool firmly with both hands
while working and ensure a safe and firm
stance. The power tool must be held firmly in
both hands.
► Secure the workpiece. A workpiece held in a
clamping device or bench vise is better secured
than when held by hand.
► Avoid any blockage of the diamond cup disk
or excessive contact pressure during grinding.
Excessive stresses on the grinding disk increases
its load and its vulnerability, i.e. it can easier get
stuck or blocked and the risk of recoil or break-
age of the grinding disk is increased.
► Switch off the power tool if the diamond cup
disk gets blocked or you need to interrupt
your work for any reason. Hold the power tool
steady until the disk has come to a complete
standstill.
► Do not switch the power tool back on while
it is in contact with the workpiece. Allow the
grinding disk to reach its full speed before re-
commencing work.
► Only use the power tool with the protective
hood opened along wall edges. The protective
hood must always be closed when working on
flat areas.
► Check the device, cable and plug before each
use. Any damage detected must only be re-
paired by a certified electrician. Connect the
wall plug only with the machine switched off.
► When working outdoors, operate the machine
with a residual current operated circuit-break-
er (RCD) with max. 30 mA.
► Pull the mains plug and check that the main
switch is in OFF position if you leave the ma-
chine unattended, e.g. during installation or re-
moval work, in case of a voltage drop, or when
inserting/ mounting an accessory part.
► Switch off the machine if it comes to a stand-
still for any reason. This will prevent any sud-
den run-up while the machine is unattended.
► Do not use the machine if any part of the hous-
ing is defective, or if any damage is detected
on the switch, power line or plug.
► Ensure that the rotational speed stated on the
grinding disk is equal to or higher than the mo-
tor speed of the machine. Only use appropriate
accessory parts.
► The exterior diameter of the grinding cup must
match the measurements provided on the
power tool.
► Diamond cup wheels and flanges must fit ex-
actly onto the grinding spindle of your power
tool.
► Diamond cup disks must only be used for their
specified applications.
► The device may only be operated with the pro-
tective hood undamaged and fully functional.
► Only use cup wheels which are smaller than
the lamellar ring of the protective hood.
► Replace the lamellar ring when it is worn.
Rev. 3 / 13
Read the operating manual of the ma-
chine before use and comply with the
instructions contained therein!
Wear protective goggles and hearing
protection while working with the ma-
chine.
The use of a face mask is recommended
for dust-intensive tasks.
Wear protective gloves while working.