Extracting Dry Materials; Extracting Fluids; Filter - Festool CLEANTEX CT 26 E AC Manual De Instrucciones

Ocultar thumbs Ver también para CLEANTEX CT 26 E AC:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SysDoc Systainer attachment system: a Systainer
can be attached to the storage area via the two
slides [4-1].
4
4-1

Extracting dry materials

WARNING
Not suitable to vacuum hazardous or toxic sub-
stances or dusts e.g. asbestos.
The filters will not be able to capture all particles
and may exhaust them back into the environment.
Remember: A damp main filter will clog more
quickly when dry materials are extracted. There-
fore, dry the main filter before extracting dust or re-
place the damp filter with a dry one.

Extracting fluids

WARNING
Risk of injury
Do not evacuate combustible liquids!
WARNING
Risk of injury
During the following procedure, take care not to
raise dust more than is unavoidable. Moisten the
main filter with a water spray before removing it.
The main filter shall only be used for extracting
dry materials.
Before extracting fluids, remove the filter or dis-
posal bag (see chapter Changing the filter bag
and Changing the disposal bag). We recommend
using a special wet filter.
4-2
The dust extractor stops automatically when the
maximum level is reached.
Escaping foam and fluids
4-3
Switch off the machine immediately and empty
the dust container.
Special features of the CT 36 E AC-LHS
To use the mobile dust extractor in combination
with the PLANEX:
Use the accompanying kink-resistant suction
hose D 36 mm x 3.5 m-AS.
Use the accompanying special suction sleeve to
connect the PLANEX.
Insert the accompanying CT-VS closing slide
between the intake opening [1-1] and the suc-
tion hose.
Fit the tool holder as described in the accompa-
nying installation instructions.
When performing extraction work with the
PLANEX, always use disposal bags to prevent
dust from escaping into the surrounding area.

Filter

Inserting the filter bag
Open the locking clips [2-2] and remove the top
section of the machine [2-1].
Insert a new filter bag (SC-FIS-CT 26/36/48)
(Fig. [5]) in the inlet port of the dust container
and interlock it. Important: be aware that the
locking engages.
CAUTION
Changing the filter bag
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cleantex ct 36 e acCleantex ct 48 e acCleantex ct 26 eCleantex ct 36 e

Tabla de contenido