Baby auto Nico Manual De Uso página 22

5. ADJUST THE HARNESS TO THE HEIGHT OF THE CHILD.
WARNING
Always check that the harness straps are suitable for the height of
your child. The shoulders of the child should always be just below the
back slots at a suitable height (5.1).
Changing the harness height
1. Adjust the height of the harness, by pressing the harness
adjustment button and pulling the harness straps towards you to
loosen them (5.2).
2. Then unhook one of the harness connector straps at the back of
the seat and pull the loose strap towards the front of the seat (5.3
& 5.4).
3. Insert the harness strap into the
at the front of the seat. Then insert the harness strap into the
appropriate upper or lower slot at the rear of the seat (5.5).
4. Reinsert the harness strap in the harness connector on the back of
the seat. At the same time reinsert the harness protective tape to
the harness connector protector (5.6).
5. Then, do the same with the other harness strap. Verify that the 2
harness straps go through the slots at the same height. Do not use
the upper guides of the child seat. These should only be used to
guide the vehicle's safety belts.
Fastening the harness
1. Join the 2 buckle metal connectors (5.7).
2. Pass both connectors through the slot in the upper part of the
buckle until you hear a "click" (5.8).
3. Always make sure the harness is properly fastened by pulling the
harness straps upwards.
4. To unfasten the harness press the red button on the buckle
downwards (5.9).
22 Child restraint system
L slot of the fabric and backrest
NICO