Miele UO 5005-30 Instrucciones De Montaje página 6

Produktgruppe 591
6 von 28
en
Parts required
Quantity Mat. no.
1 01496700
1 01514720
Note
This service and repair work should only be carried out by a suitably qualified electrician (with specialist training, knowledge and
experience, and recent related work experience) in accordance with all appropriate local and national safety regulations.
Servicing, modification, testing and maintenance of electrical appliances should only be carried out in accordance with all appropriate
legal requirements, accident prevention regulations and valid standards. All regulations of the appropriate utility supply companies and
standards relating to safety (not limited to electrical safety) are to be complied with.
Danger!
Risk of injury during fitting.
Risk of electric shock. Even with the machine switched off, mains voltage may be applied to some components. Before any service
work is commenced, the machine must be disconnected from the mains.
Fitting can only be carried out with the washing machine or tumble dryer not installed. For deinstallation, see the appropriate
operating instructions.
Risk of crushing. Wear slip-proof working gloves and safety shoes.
Risk of crushing. When carrying out work, ensure that parts of the body, especially the hands and feet are not positioned under or
between machines.
Risk of accident. Ensure that children or pets cannot access the work area while fitting work is being carried out.
Risk of toppling over. Risk of injury due to incorrect fitting.
Always bolt the machine to the plinth.
Secure the plinth to the floor with the fastening accessory, Mat. no. 01497252, supplied with the kit. This is supplied with the kit.
The plinth must not be used with a washer-dryer stack.
Note
The plinth may only be used with the following Miele models:
PW 5062, PW 5064, PW 5065, PW 6055, PW 6065
WS 5425, WS 5426, WS 5427, WS 5428
PT 5135 C, PT 5136, PT 7135 C, PT 7136
T 5205 C, T 5206
Note
Tools required:
Spirit level for plinth levelling
Open spanner 10 mm for M6 nut
Torx screwdriver, T 20
Disconnect the machine from the electrical mains and ensure power cannot be switched on again in error.
Plinth UG 5005-30: Casing removal:
Remove the front panel, Fig. 8.
Remove the side panels, Fig. 8.
12.09.2012 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
Designation
Plinth UO 5005-30
Plinth UG 5005-30
M.-Nr. 04891571