Tabla de contenido
Publicidad
20 von 61
Danger due to incorrectly carried out service and repair work
WARNING
Danger due to incorrectly carried out service and repair work.
There is a risk of serious damage, injury and even death if service and repair work is carried out incorrectly.
A
Service and repair work should only be carried out by a suitably qualified electrician with specialist training,
knowledge and experience.
A
All appropriate safety regulations must be taken into account.
A
Read the technical service documentation (TSD) before starting service work.
Measures to be carried out before starting any service work
- Carry out appropriate electrical safety checks.
- Disconnect all machine utility connections in accordance with the operating instructions.
Measures to be carried out after service work has been completed
- Carry out appropriate electrical safety checks.
- Check the appliance for correct operation.
Risk of cuts
WARNING
Components are sharp.
Risk of cuts during service work.
A
Wear protective gloves.
Risk of injury due to excessive physical strain
WARNING
Risk of injury due to excessive physical strain.
Spinal injuries.
A
The relation of the weight of the machine to the physical strength of the technician must be taken into account.
For machine weight details, see the operating instructions.
Stand preparation
A
Level the stand on the floor.
A
Mark the hole positions.
A
Drill the following holes in the marked positions.
- APCL007, APCL011 (47cm/18.5" stand): 12mm (0.5") diameter, approx. 65mm (2.5") deep
- APCL020 (75cm/30" stand): 16mm (0.625") diameter, approx. 120mm (4.75") deep
A
Insert the plugs in the holes.
A
If a dryer is to be installed on the stand, secure each clamping plate to the rear of the stand with two 6 x 12 screws;
see Fig. 1.
A
Level the stand using the provided washers (2); see Fig. 2.
A
Fasten the stand to the floor with the provided wood screws (3) and B13 washers (4); see Fig. 2.
Installing a washing machine on the stand
A
Unscrew and remove the machine feet.
16.07.2020
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 11313371
Publicidad
Tabla de contenido
