ELT PRO-RGB-W-C01 Manual De Instrucciones página 2

R
Especialidades Luminotécnicas
Pol. Malpica c/ E nº 11
)
+34 976 573 660
INSTRUCTION MANUAL
PRO-RGB-W-C01 LED Controller
Technical characteristics
Ref. Input Voltage
9955913 12 - 24 VDC
Dimensions
Operation
Connect the device according to the wiring diagram.
Pair the RF receiver with the RF remote:
1. Connect and wire up the RF receiver correctly. Turn on the remote.
2. Press the RF Code Key button on the receiver, then immediately click on a zone number to pair the receiver to
the selected zone, in the event the remote controls several zones (omit this step if not applicable). Next, touch
the colour wheel or slider bar on the remote (if the remote does not have these functions, press or touch any
key). When the LED light on the receiver flashes twice, the device is successfully paired.
Note: a receiver can be paired with up to 8 remote controls.
To cancel pairing:
1. Connect and wire up the RF receiver correctly. Turn on the remote.
2. Press and hold the RF Code Key button on the receiver for over 3 seconds until the LED light flashes twice.
Pairing is successfully cancelled.
S.A.U.
50016 Zaragoza ( SPAIN )
:
*
elt@elt.es http://www.elt.es
Key features
PRO-RGB-W-C01 can control RGB (3CH) or
RGB + White (4CH) LED Strips from an RF
remote control.
The controller can be synchronised with
up to 8 remotes at the same time.
Radio Frequency : 868 / 915 / 434 MHz
Output Current Output Power Observations
3 x 5 A - RGB 12V - 60W CH
Constant voltage
4 x 5 A - RGBW 24V - 120W CH
17
Ø 3,5
47
139
145
Function overview
DC Power input
RF Code Key
RF Code Key: to pair with the RF remote
Wiring diagram
L
N
LED driver
L
N
LED driver
Safety warnings
1) This product must be installed and serviced by qualified personnel.
2) IP20. Protect from sun and rain. For outdoor installations, make sure it is housed inside a waterproof enclosure.
3) Always ensure the device is installed in a properly ventilated area to avoid overheating.
4) Make sure that the output voltage of any LED power supply used complies with the working voltage of the product.
5) Never connect any cables while the power is on. To avoid short circuits, check the connections are correct before
switching on.
6) Check that cables are securely attached to the terminal blocks.
7) Please contact your supplier for updated information.
8) DO NOT install with power connected to the device.
9) DO NOT expose the device to humidity.
Subjet to changes without notice
9052437_MAN - v2 - January 2018
Common Anode Output (+)
CH 1 : R output (-)
CH 2 : G output (-)
CH 3 : B output (-)
CH 4 : W output (-)
RGB LED STRIP (3CH)
R
PRO-RGB-W-C01 G
B
LED controller
RGB LED STRIP (4CH)
R
PRO-RGB-W-C01 G
B
LED controller
W