Connect The Speakers - Onkyo CR-N775D Serie Manual De Instrucciones

> Before Start > Part Names

Connect the Speakers

Install
1
2
a Speaker Cable
8
> Install > Initial Setup
1
2 2
1/2˝
(12 mm)
3 3
a
a
> Playback
3
Supplementary information | Advanced Setup | Others
Refer to the illustration to connect the speaker system.
Twist the wires of the speaker cable tightly before
inserting into the SPEAKERS terminals. After inserting
the speaker cables, tighten the terminals firmly by
turning to the right. Make correct connection between
the unit's jacks and speaker's jacks (i to i and j to
j) for each channel. If connection is wrong, a bass
sound may become poor due to reverse phase. Also
make sure the exposed wires of the speaker cables do
not stick out of the speaker terminals when connecting.
If the exposed wires of the speaker cables touch the
rear panel or the i and s wires touch each other, the
protection circuit may be activated and the power may
turn off.
You can also connect a subwoofer with a built-in
amplifier to boost bass playback even more. Use a
subwoofer cable for connection.