Publicidad
Idiomas disponibles
Idiomas disponibles
Produktgruppen 512, 592
7 von 26
Disconnect the machine from the steam supply (if applicable) and electric mains, and ensure utilities cannot be
switched on again in error.
Remove the 2 side panels and 2 service panels, Fig. 1.
Unscrew the machine floor fastening.
Note
If present, remove any spacer plates that may be in use and take care to note the number fitted and their positions
so that they can be refitted in an identical manner.
Disconnect the floor drain.
Use a suitable lifting aid to raise the machine by approx. 200 mm.
E.g. pallet truck and suitable wood blocks.
Danger!
Take suitable measures to ensure the machine cannot fall.
Unscrew the 4 floor fixing brackets, Fig. 2, Pos. 1.
Fit the pre-fitted feet, Fig. 4, Pos. 2, on the left and right under the machine base frame and screw them in position.
(On each corner, 2 screws from the inside and 1 screw from the bottom, see Fig. 4, Pos. 3.)
Warning!
Use the new DM 6 x 12 screws from the accessory pack to secure the pre-fitted feet to the base frame.
Extend the connection between the machine drain outlet and the on-site drain by approx. 170 mm.
Lower the machine and return it to its original position.
Check that the machine is perfectly level in all directions.
If necessary, level the machine by fitting spacer plates as appropriate.
Fit the floor fixing bolts through the fixing brackets in the existing holes, Fig. 3, Pos. 1.
Fit the 2 front plinth panels, Fig. 3, Pos. 2, at the front and back, and align them with the corners of the machine.
Fit the 2 side plinth panels, Fig. 3, Pos. 3. Readjust the 2 front plinth panels if necessary, Fig. 3, Pos. 2.
Refit the 2 side panels and 2 service panels.
Carry out appropriate electrical safety checks.
Reconnect the machine to the mains and the steam supply (if applicable).
en
fr
Pièces nécessaires
Nombre
Mat.-Nr.
1
07493360
1
07493370
1
07493380
1
07493390
1
07493400
1
07493410
1
06585110
02.03.2012
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Désignation
Jeu de montage du socle UG 6163 octobleu pour PW 6163
Jeu de montage du socle UG 6163 inox pour PW 6163
Jeu de montage du socle UG 6243 octobleu pour PW 6243
Jeu de montage du socle UG 6243 inox pour PW 6243
Jeu de montage du socle UG 6323 octobleu pour PW 6323
Jeu de montage du socle UG 6323 inox pour PW 6323
Tuyau HTEM DN 75x250 - rallonge de la vidange au sol de minimum 170 mm
Umbau- und Montageanweisung
M.-Nr. 07564361
Publicidad
