LIGHTING
LIGHTING INSTRUCTIONS
1.
The appliance must be assembled as per the
assembly instructions.
2.
Ensure LP cylinder is full and properly connected to
the regulator.
3.
Ensure there are no gas leaks in the gas supply
system. See: "Leak Testing." (Page 6)
4.
Ensure that the venturi tubes are properly located
over the gas valve orifices. See "Venturi Tubes."
(Page 7)
5.
Ensure that ignition wires are connected.
6.
Carefully review all instructions on the information
plate attached to the gas stove.
7.
WARNING: Always open lid before lighting and
do not lean over gas stove while lighting.
8.
WARNING: Do not close lid when burners are lit
or hot.
9.
Do not place food directly on the grid.
10.
Set control knobs to "OFF" and turn on the gas supply.
LIGHTING THE BURNER:
a.
Open gas stove lid and leave open.
b.
Push and turn control knob to "HIGH."
c.
Push ignitor 3 or 4 times or use match to light.
d.
Burner should ignite within 5 seconds; turn off gas
source immediately if ignition does not occur in this
timeframe.
A. BURNER CONTROL
B. IGNITOR
C. HANDLE
D. CYLINDER
E. REGULATOR
F. CYLINDER VALVE
G. CYLINDER ADAPTER HOSE
8
CAUTION - Check your gas stove after lighting.
All burner ports should show a 2.5cm / 1" flame on "HIGH."
If any of the following symptoms occur there is probably a
blockage in the venturi tubes. Shut off gas at once and
clean the venturi tubes. See "Venturi Tubes." (page 7)
1. You smell gas.
2. A flashback fire occurs.
3. Your gas grill heats unevenly.
4. The burners make popping noises.
IF BURNER DOES NOT IGNITE:
1.
Push and turn control knob to "OFF." Wait 5 minutes
then try again with control knob set at "MEDIUM."
2.
If any burner will not light, see "Troubleshooting" (page
11). If problem persists, do not attempt to operate the
appliance; contact OMC, your dealer or an approved
service center.
SHUTDOWN:
1. Turn off cylinder valve.
2. Turn control knobs to "OFF."