EASYHOME ST-55 Manual Del Usuario página 6

Operation instructions
Steaming Fabrics and Linens
NOTE: The water reservoir must be filled before proceeding with the
following steps.
1 Gently pull the cord out from the rewind mechanism. Do not pull past the
red marking on the power cord. Maximum length is marked by this red label.
2 Plug the steam power cord into an electrical outlet. The heater indicator
light will illuminate when its turned on.
3 The steamer will emit steam after approximately 3 minutes.
4 Direct the steamer nozzle towards the materials you want the steamer.
5 Keep the flow of steam focused on the material. Using a slight back
and forth motion will further enhance the steaming process.
Steaming Garments
1 Place the garment on a clean hanger.
2 Start to steam from the bottom of the garment. The steam will rise along
outside and inside of the fabric, removing wrinkles. Continue to steam
slowly from bottom to top of the garment.
3 Point the steam away from the garment and smooth the fabric
with your free hand.
4 Repeat the above steps as necessary until garment is free of wrinkle.
4