Placement And Mounting - Ecler AUDEO Serie Manual De Instrucciones

5. PLACEMENT AND MOUNTING

Consider following general rules:
•
Place the loudspeaker cabinet on solid and firm surfaces.
•
No obstacles should stand between the enclosures and the audience.
•
Although the speakers can be used outdoors, they should not be directly exposed to
sunlight or rain.
•
Always adjust the output sound pressure levels to the reproduction requirements. Despite
their small size, they can produce significantly higher pressure levels than home speakers.
The AUDEO packaging contains everything you need to install the enclosures:
•
Two articulated wall mounts (one per cabinet).
•
Four screws and four 6 mm wall anchors (two per cabinet).
•
Two M5 Allen key.
•
Two safety steel sling to protect against accidental detachment (one per cabinet).
•
Two Euroblock connectors (one per cabinet).
•
An instruction manual.
•
Two warranty forms (one per cabinet).
Wall mounting procedure:
1. Drill two 6 mm holes in the wall, coinciding with the position of the mount holes.
2. Insert four 6 mm rawl plugs in the holes.
3. Fasten the safety guide at the back of the mount (as shown in the diagram).
4. Put the mount in place, after first passing the sling and speaker cable through the square
hole of the mount. Insert and tighten the screws supplied, holding the mount firmly against
the wall.
5. Use the Euroblock connector to connect the speaker cable to the connector on the back
part of the cabinet. Make sure to line up the right polarity on the terminals and ensure the
cable goes through the square hole on the mount guide.
6. Put the cabinet in its final position by sliding it vertically downwards so that the guide on
the back fits into the mount guide.
7. Fasten the safety cable to the back of the cabinet to prevent it from accidentally falling and
causing damage to objects and/or people.
8. Move the cabinet until it is in the correct position in terms as regards the vertical and
horizontal axes. Tighten the Allen screws on the mount to secure that position at both
axes.
9. Set the power switch to the desired position.
10. Conceal the excess length of the guide and cable (a few centimetres) by inserting it in the
opening in the mount.
6