English - Teac TASCAM TT-M1 Manual Del Usuario

Introduction
Read this manual thoroughly before using the
product, and keep it handy for future reference.
The TT-M1 is a special controller for the TAS-
CAM CD-X series of CD players (hereafter
referred to as CD-X). When a record player
equipped with the TT-M1 is being used to con-
duct scratching, the controller detects the
turntable's rotating direction and speed and trans-
fers them to the CD-X. The CD-X then plays
back the scratching on a CD with great accuracy.
• The names of the companies and products that
appear in this document are the trademarks or
registered trademarks of their respective hold-
ers.
• Do not connect the product to any equipment
other than the CD-X.
• This product is powered by the CD-X unit.
When the product is not in use, always turn off
the POWER switch and raise the roller to an
upright position.
Installation
The TT-M1 can be attached to the following
record players using accessory adapters. Install
the adapter in the specified position on the base
unit and then affix the product to the record play-
er.
Model
Technics SL-1200MK2
Technics SL-1200MK3
Numark TTX1
Vestax PDX-2000
If you want to install the TT-M1 on models other
than these, fix it in place with double-sided tape
or by other means.
2

English

Mounting
hole Adapter
T2 T2
T3 V
N N
V, T2 V, T2
Technics SL-1200MK2
Attach adapter T2 to mounting hole T2 and insert
the TT-M1 into the dust cover holder.
Technics SL-1200MK3
Attach adapter V to mounting hole T3 on the
back of the base unit, and insert the TT-M1 into
the headshell stand.
Numark TTX1
Attach adapter N to mounting hole N on the back
of the base unit, and insert the TT-M1 into the
headshell stand.