Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3.2. Fixing and hanging the system
The EPC 215D acoustic enclosures feature 2 lateral insets specially suited for installing
ATM's MEGS PIVOTAL SERIES rigging system.
To mount this parts, simply remove the little plates covering the insets and follow the
instructions that came with the MEGS PIVOTAL SERIES.
On the rear part of the EPC215D you will also find a fitting for mounting a piece which
lets you slide through a ribbon for tilting the enclosures once rigged.
ATM Group, Inc • 21000 South Wilmington Avenue • Carson, CA • 90810-1247 •
Tel 310.834.5914 • Fax 310.834.3042 • www.atm-fly-ware.com
Or contact your nearest ECLER Technical Service Department
3.3. Mounting the wheels
All the EPC cabinets have embeded nuts where the wheels can be
attached thus easing the transport for mobile systems. The WH 200 ECLER
kit is composed by 4 free-wheels.
3.4. Connecting the system
The EPC200 processor combined with the EPC acoustic cabinets must be powered with
the fourth generation ECLER amplifiers because they are the only ones that accept the AC3 anticlip
module
Mains supply. Although the PAM2600 fourth generation SPM amplifiers are equipped
with a "soft start", properly dimensioned mains wiring and magnetothermal switch must be
provided (220VAC values):
Audio signals. The interconnections will be done accordingly to diagram 6.2. keeping in
mind the following points:
A- All the input and output signals of the processor are balanced with XLR 3 connectors
and the pin assignment is as follows:
8
Mag. min 25A
HOT or direct signal
COLD or inverted signal
GROUND
Recommended wire section: 6mm
>
Pin 2
>
Pin 3
>
Pin 1
Publicidad
Tabla de contenido
