Connections - Ecler IW6 Manual De Instrucciones

4. CONNECTIONS

The connection
clamps for stripped wires. Once they are
connected, all you have to do is choose the
unit's power and mode of operation using a
simple screwdriver. Always pay attention to
the polarity.
The IW6
factory with the switch in 100V/70V
position. If it is connected to a low-
impedance amplifier, the speaker will not be damaged, but will perform way below its full
potential. If the speaker is accidentally connected to a 100V/70V line in the 8Ω position, it will
be severely damaged.
Use the 6 revolving fasteners included to easily install the units. For more information on
how to install the units, please see section 5 of this manual.
terminals are
are shipped from
5