Introduction; Voltage; Extension Cord; Technical Data - Walter MATE III Serie Manual Del Usuario

INTRODUCTION

Your WALTER power tool is precision built to meet the highest industrial
standards. For maximum performance and longest tool life, follow the
operating instructions and service procedures outlined in this manual.
This tool is CSA certified.
This tool is double insulated, it does not have to be grounded.
It may be safely operated from a grounded or ungrounded
receptacle. It is supplied with a 2-conductor power cord and a
polarized plug (one blade wider than the other). The plug will
fit only one way into a polarized outlet. If the plug does not fit,
have the outlet replaced by a qualified electrician. If an extension
cord is necessary, only one that is polarized must be used. Do
not change the plug in any way.
In order to maintain the safety features of the double insulation, the
housing must not be drilled to affix nameplates or the like. Self-adhesive
labels may be used for this purpose.

VOLTAGE

Before connecting the tool, make sure that the voltage shown on the rating
plate is the same as the power source.
Operating the tool on a voltage other than specified on its rating plate, may
result in personal injury to the user and damage to the unit.

EXTENSION CORD

When an extension cord is required, use one that is sufficient for the power
requirement of the tool. Extension cords of inadequate wire size cause a
serious drop in voltage, loss of power and possible motor damage. To limit
line voltage drop to a safe level, refer to the following table:
Length in meters 8
Length in feet 25
Wire size AWG 14
NOTE: Extension cords that are used outdoors must be approved for outdoor use.
15 23 30
50 75 100
14 12 10
8

TECHNICAL DATA

MODEL 6268 C
Voltage .........................120 V AC; 60 Hz
Amperage .....................12
No-load speed ..............POS.A POS.B POS.C POS.D POS.E POS.F POS.G
.....................................1,000 1,400 2,000 2,400
Spindle Thread .............5/8" -11 NC
Weight ..........................2,87 kg - 6lb. 5oz
MODEL 6268 C
Voltage .........................220 - 240 V AC; 50 - 60 Hz
Amperage .....................7,2
No-load speed ..............POS.A POS.B POS.C POS.D POS.E POS.F POS.G
.....................................1,000 1,400 2,000 2,400
Spindle Thread .............M14
Weight ..........................2,87kg - 6lb. 5oz
2,800 3,300 3,800
2,800 3,300 3,800
9