Fixing And Hanging The System; Mounting The Wheels; Connecting The System - Ecler EPC7000 Manual De Instrucciones

3.2. Fixing and hanging the system

The EPC215D acoustic enclosures feature 2 lateral insets specially suited for installing
ATM's MEGS PIVOTAL SERIES rigging system. Four different KITS are available depending on
the installation requirements (see figure A)
To mount this parts, simply remove the little plates covering the insets and follow the
instructions that came with the MEGS PIVOTAL SERIES.
On the rear part of the EPC215D you will also find a fitting for mounting a piece which
lets you slide through a ribbon for tilting the enclosures once rigged.
ATM Group, Inc • 21000 South Wilmington Avenue • Carson, CA • 90810-1247 •
Tel 310.834.5914 • Fax 310.834.3042 • www.atm-fly-ware.com
Or contact your nearest ECLER Technical Service Department

3.3. Mounting the wheels

All the EPC cabinets have embeded nuts where the wheels can be
attached thus easing the transport for mobile systems. The WH 200 ECLER
kit is composed by 4 free-wheels.

3.4. Connecting the system

Connection to the acoustic cabinet. This connection must be done with, at least, 3mm
cable (we recommend 6mm). The amplifier output and the acoustic cabinet input connectors are 4
pin SPEAK ON (see diagram B). The mid-treble cabinet will be connected as follows:
The bass reinforcement cabinet only uses pin 1+ and pin 1-.
8
Treble +
Treble -
Mid +
Mid -
> Pin 2+
> Pin 2-
> Pin 1+
> Pin 1-