Painting - Ecler IC SB10 Manual De Instrucciones

1. Insert the ring in the hole previously drilled in the
ceiling according to the procedure described on
the preceding page.
2. Place the ring in the hole as illustrated. It is
important that the tabs on the side of the ring are
placed exactly as shown.
3. Insert the brackets into the hole, fix them in place
on the tabs on the side of the metal ring and line
them up so that both V-shaped ends rest on the
ceiling's existing grid.
4. Use the screws provided to attach the brackets to the ring.
The metal ring can also be use for non-drop ceilings, being as it distributes the weight
uniformly across the contact surface.
N.B.: The high performance of the IC SB10 speaker can result in substantial vibrations,
which may be transmitted to the existing materials and structures of the ceiling where it is installed.
Depending on the materials and structures in place, we recommend using shock absorbing
materials, such as neoprene, to eliminate undesired vibrations.

6. PAINTING

The IC SB10 is designed to be painted, meaning it can be installed anywhere, regardless
of the design and look of the place where it will be used.
Follow these instructions to paint the speaker:
1. Remove the protective grating from the speaker using the hook provided in the packaging.
2. Once the cut/paint template has been separated into two parts, use the inside disk to
protect the speaker cone. Place it tight on the cone. The points still on disk after it has
been separated help to fix it tight into place. The outside part of the template can be put
on the back part of the speaker, lining
it up with the plastic circle, to protect
the back part from splattering if you
are using spray paint.
3. Paint the protective grating and the
speaker separately. Make sure that
the small holes in the grating are not
blocked by paint. Use an appropriate
air drying paint.
4. When the paint is dry, remove the
protectors. The unit is ready to be
installed.
6