Publicidad
Idiomas disponibles
Idiomas disponibles
STORAGE
POSiTiON
For more compact storing the mower can be stored in an upright position,
with the handle folded over as shown in figure Z. The mower can also
be charged In this upright position.
To place the mower in a convenient storage position:
1. Remove safety key.
2. Hold handle with one hand, pull and rotate one handle quick adjust
knob on mower handle a quarter-turn to release the pin from the
metal plate hole. Handle quick adjust
knob will remain in this retract-
ed position. Repeat for the opposite side handle quick adjust
knob.
Now the handle is free to move into another handle height position.
3. Swing the handle forward over the front of the mower.
4. Pull and rotate handle quick adjust knobs
a quarter-turn to re-
engage pins into metal plate holes. Shake handle slightly to ensure
handle pins are fully engaged in the metal plates.
5. Now the mower can be rotated back onto its rear wheels as shown in
figure Z.
6. Be careful not to pinch power cord when folding and unfolding handle.
CAUTION:
If handle is not in locked position in upright storage posi-
tion, the handle may fall back and cause injury or damage. Place blade
side against vertical wall.
CAUTION:
Pinch point. To avoid being pinched, keep fingers away
from area between handles when lowering.
OFF-SEASON
STORAGE
1. In warmer climates to ensure optimal performance,
it is recommended
that the battery be maintained on constant charge.
2. The mower may be stored with the charger disconnected
if all of the following conditions are met.
- the battery is fully charged before storing. (Failure to store fully charged wilt shorten battery life).
- the average temperature of the storage location is below 50°F (10°C).
- storage duration is less than 6 months.
BATTERY
SERVICE
AND INSTALLATION
When service or repair is required, it is recommended
that you take your mower to an authorized Black & Decker Service Center.
When servicing or replacing batteries, please note:
• Use only the same type and size of battery as originally supplied.
• Do not dispose of the batteries in a fire. The cell may explode. See Battery Recycling information below.
• Do not open or mutilate the batteries. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if
swallowed.
_,__, ._,_
• Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets, and keys. The
__
battery or conductor may overheat and cause burns.
THE RBRC
TM
SEAL (BATTERY
RECYCLING)
The RBRC
TM
(Rechargeable
Battery Recycling Corporation)
Seat on the lead acid battery (or battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have already been paid by Black & Decker. In some areas, it is illegal to place spent lead acid
batteries in the trash or municipal solid waste stream and the RBRC program provides an environmentally
conscious alternative.
RBRC in cooperation with Black & Decker and other battery users, has established programs in the United States and Canada to
facilitate the collection of spent lead acid batteries. Help protect our environment
and conserve natural resources by returning the lead acid
battery to an authorized Black & Decker service center or to your local retailer for recycling. You may also contact your local recycling center for
information on where to drop off the spent battery, or call 1-800=544-6986.
Accessories
Recommended accessories for use with your mower are available from your local dealer or authorized service center. If you need assistance
regarding accessories, please call: 1-800-544-6986
Z_ WARNING:
The use of any accessory not recommended
for use with this lawn mower could be hazardous.
p/n 90564917
MULCH INSERT
pin 242501-05
REPLACEMENT
GRASS
BAG
MB-1200
REPLACEMENT
BLADE
RB-3610
OR RB-3612
BATTERY
PACK
FOR
MODEL
CM1936Z.
RB-3612
BATTERY
PACK
FOR
MODEL
SPCM1936.
HERE ARE SOME HELPFUL HINTS TO GET THE MOST FROM YOUR BLACK & DECKER CORDLESS
MOWER...AND
KEEP YOUR LAWN
LOOKING BEAUTIFUL
1.
Lawns should first be mowed in the spring when the grass is about 2-1/2 to 3 inches (63mm) to (76mm) high. Mowing too early restricts the
grass root systems which renew themselves
every spring. New grass should be mowed when it is about 2-1/2 inches (63mm) high.
2.
Do not remove too much grass blade surface at one time...never more than 1/3 of the leaf height during each cutting. Cutting too close
"shocks" sensitive grass blades, resulting in a shallow root system and thus making it more difficult for your lawn to reach water in the soil.
3.
Lawn care experts say that excessively close cutting is responsible for much of the difficulty experienced
on many lawns. The depth and
strength of the roots of grass are almost exactly proportional to its growth. Grasses of mature lawns often are seriously injured when mowed
shorter than 1-1/2 inches (38mm), and a height of 1-1/2 to 2 inches (38mm) to (51mm) is preferred on large lawns.
15
Publicidad
