S&P CADB/T-N PRO-REG Instrucciones De Uso página 40

Horizontally confi gured models of 45, 55 and 80
Horizontal models size 45, 55 and 80 have feet and central supports and shall be installed on a fl at
surface and cannot be hung. In order to distribute the weight of the assembly and reduce fl exing of the
structure, the units are mounted over one or two supports (depending on model) located in the central
part of the unit. These supports must be in contact with the ground or with fl at surface. It is essential
that the weight of the equipment is distributed between all points of support to prevent deformation.
The installer must make sure that the ceiling structure and the securing elements can bear the
weight of the device, taking into account that it is a dynamic load.
Superfi cie
Flat
plana
surface
Pies
Feet
Soportes centrales
Central supports
Vertical models
Vertical confi guration models have special support feet. Once the device has been fi tted in the correct
position, the installer must connect it with the air duct, the mains connection, both for the motors,
and for the batteries, if applicable, by means of the terminals in the terminal connection box and the
connection with the hot water closed circuit for the water battery, if applicable. The tube for evacuating
condensate will be secured according to the instructions in the corresponding section.
Drain (Fig.1)
Desagüe (Fig.1) Cable Remote terminal Manual
a)
b)
c)
x2 x2 x2 x1 x1 x1
Drain (Fig.1)
a) Drainpipe
b) Female screw
c) Joint ring Install the two drains as indicated icated
in the following drawing:
a)
c)
b)
40