RADIO OPERATION
1. Slide the FUNCTION switch to RADIO position, the POWER indicator will
illuminate.
2. Slide the BAND switch to select the desired wave band: AM/FM ST.
3. Tune to required station by rotating the TUNING KNOB.
4. Rotate the VOLUME CONTROL to comfortable volume level.
5. Extend the TELESCOPIC ANTENNA to its full length if you are listening to FM
broadcasting. Gently move the unit back and forth to get the best reception
when you are listening to AM program, or place the unit in an open place.
Note: The FM STEREO indicator will be on if you are receiving FM stereo
program.
6. Turn off the radio by switching the FUNCTION switch to "OFF" position
CD/MP3 OPERATION
Discs for playback
This system can playback all digital audio CD/MP3/WMA discs, finalized digital audio
CD-Recordable (CD-R) discs and finalized digital audio CD-Rewritable (CD-RW)
discs.
LOADING A DISC
1. Set the FUNCTION switch to CD/MP3/USB position.
2. Open the CD door, "OP" will be shown on the display.
3. Place an audio CD into the tray with the label side facing up.
4. Close the CD door, the total number of tracks will appear in the display.
5. To remove the CD, open the CD compartment lid, grasp the CD by its edges, and
carefully take it out.
Note:
• To ensure good system performance; wait until the disc tray completely reads the
disc before proceeding.
• If no disc is loaded into the compartment, or the disc is placed upside down, the
display will show "n0d".
PLAYING A DISC
1. Press the PLAY/PAUSE/STANDBY button on unit or on remote control to start
playback. The playback starts from track 1, "" will appear on the display.
2. To interrupt playback, press the PLAY/PAUSE/STANDBY button, "" and the track
number will flash on the display.
3. To resume playback, press the PLAY/PAUSE/STANDBY button again.
4. To stop playback, press the STOP/USB button, the total number of tracks would
appear in the display.
EN
15