Jet Swim Motion
Installation
The pump section is installed on a stable surface in a dry area. Make sure that the area is well venti-
lated and is equipped with a drain in order to prevent flooding.
All installation of stainless steel parts shall be done using tools solely intended for such material
in order to maintain its corrosion-resistance. All screws should be lubricated with Molykote®
(included). The recess must be installed horizontally with the buttons on the lower side. The edge
of the flange on the recess has a small jacks (A) that aid in marking and checking the horizontal
placement, see Fig 1.
See the Section entitled "Dimensions" for installation measures, placements etc.
N.B.!
The starting hose must be set in a loop 150-200 mm above the surface of the water.
Never run the pump dry. This will damage the axle seal.
Installation in thin pool wall with liner
(wood, sheet metal, plastic, etc.)
E
Box 728, SE-194 27 Upplands Väsby, Sweden
Phone +46 8 59411050, Fax +46 8 59086880
1. Make an Ø258 mm hole in the pool wall. Use the niche as the template for six Ø5 mm holes (see B fig 1).
2. Attach the niche (see Fig 1) in the pool wall with the included screws.
3. Attach the self-adhesive gasket onto the niches flange.
4. Install the pool liner with water up to 5 cm under the house.
5. Screw the clamping ring and the rubber gasket in place against the niche, 5 Nm in torque. The screws must be lubricated.
6. Cut away the pool liner against the inside of the clamping ring.
7. Install the intake grate and the stainless-steel front. (These screws must be lubricated.)
8. Connect the hose for the air admixture and tighten the hose clamp.
Attach the other opening of the hose 100 mm above the surface of the water behind the pool wall.
9. Connect the start hose (with a look at least 150mm over the surface of the water) to the control box.
10. Connect pipes and valves to the pump. All threads must be tightened with thread tape.
11. Electrical connection shall be made by an authorised electrician.
1
3
4
13
14
Surface treatment
The tolerance class in accordance with this
Assembly drawing no.
part of ISO 2768-1
Jet swim motion tunnväggig sprängskiss
7
2
15
Sample image: wooden frame with liner
1. Niche
2. Screw
3. Nut
4. Washer
5. Self-adhesive gasket
6. Gasket
7. Clamping ring
8. Screw
9. Inlet grate
10. Screw
11. Front
12. Screw
13. Pool framework
14. Wall covering
15. Liner
5
Designed by:
Drawn by: Date
RJ
2018-01-19
Art.no.
Scale
Drawing number
1
3
4
13
14
11
ENGLISH
UP
A
Figure 1.
Recess seen from the front.
9
6
10
8
Approved by:
Revised by: Date
Rev.no.
7
2
15
B
(6x)
A
S
E
T
p
Box 728, SE-194 27
Phone +46 8 594110
11
12