Digital Effect Processor - Phonic POWERPOD 750RW Manual Del Usuario

Digital Effect Processor

21. Effects On Button and Indicator
Pushing this button will turn the built-in effect processor on and off.
When the effect processor is activated, the corresponding LED will
light up to indicate so.
22. Program Control
This control will allow users to select one of the 16 built-in digital
effects of the Powerpod powered mixer. The effect names that
correspond with the numbers can be found on the top of the
mixer's face, or in the digital effect table.
23. Parameter Control
Turning this control will adjust the one main parameter of the
selected effect. Each effect's parameter can be found on the digital
effect table.
21
Master Section
24. EFX To Monitor Control
This controls the level of the processed signal from the built-in
effect processor, that is sent to the Monitor mixing bus.
25. EFX To Main Control
This controls the level of the processed signal from the built-in
effect processor, that is sent to the Main 1/2 mix.
26. AUX In Controls
The Powerpod 750RW features a single AUX in control (located
beneath the Main Equalizer) that adjusts the final level of the AUX in
input that is sent to the Main mix.
POWERPOD 750RW
27. Tape In
The Powerpod 750RW features two Tape In controls. One that
adjusts the final level that is sent to the Monitor mix (the upper
control), and another that controls the final level that is sent to the
Main mixing bus (the lower control).
28. Graphic Equalizers
These graphic equalizer allows you to adjust the frequency
response of a signal, with a maximum of ±12 dB of signal boost
or cut for each of the frequencies. The Powepod 750RW features
two 7-band Graphic Equalizers. The uppermost equalizer is for
alteration of the Monitor signal (when the EQ switch is in the
appropriate position it becomes the Main 2 EQ), where the lower
equalizer is for the Main 1-2 signal (or the Main 1).
29. EQ IN and Indicator
This button activates the graphic equalizer in which it accompanies.
The corresponding LED indicator illuminates when the EQ is
activated.
30. EQ Select Switch
This switch enables you to select the way you utilize the pair of
Equalizers on these models. The uppermost position it enables
you to use the top equalizer for the Monitor signal, and the bottom
equalizer for the Main 1/2 signal; the lower position enables the
equalizers to be used for the mixer's Main 1 and 2 signals.
24 25 27 30 29
22
23
28
26 27 29
5