Whirlpool 4KNED4400 Manual De Uso Y Cuidado página 12

TROUBLESHOOTING cont.
First try the solutions suggested here to possibly avoid the cost of a service call.
if you experience Possible Causes Solution
Cycle time too short Automatic Dry cycle ending early.
Lint on load
Stains on load or drum
Lint screen clogged.
Dryer fabric softener not properly
used.
Loads are wrinkled Load not removed from dryer at the
end of the cycle.
Dryer tightly packed.
Odors Have you recently been painting,
staining, or varnishing in the area
where your dryer is located?
Is the electric dryer being used for
the first time?
Load is too hot Were laundry items removed from
the dryer before the end of the
cycle?
Was a high temperature cycle
used or was TEMPERATURE
control set to high?
The load may not be contacting the sensor strips. Level the
dryer.
Use Timed Dry for very small loads. Change the Dry Level
setting on Automatic Dry cycles.
Increasing or decreasing the Dry Level setting will change the
amount of drying time in a cycle.
Lint screen should be cleaned before each load.
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by dyes in clothing (usually blue jeans).
These will not transfer to other clothing.
Select Wrinkle Prevent option to tumble the load without heat
to avoid wrinkling.
Dry smaller loads that can tumble freely reduce wrinkles from
forming.
If so, ventilate the area. When the odors or fumes are gone
from the area, rewash and dry the clothing.
The new electric heating element may have an odor. The odor
will be gone after the first cycle.
Allow Cool Down cycle to finish before removing laundry from
dryer. All cycles are cooled slowly to reduced wrinkling and
make it easier to handle. Items removed before Cool Down
may feel very warm.
Select a lower temperature, and use an automatic drying cycle.
These cycles sense the temperature or the moisture level in the
load and shut off when the load reaches the selected dryness.
This reduces overdrying, j
12