Beurer LA 40 Instrucciones De Uso página 26

After use
1� Disconnect the device from the socket and the mains adapter�
2� Remove the porcelain cover and the inner cover in an upward direction�
3� Pour any remaining water down the drain�
IMPORTANT
When pouring out the water, en-
sure that the ventilation opening is
located at the top� Ensure that the
ventilation opening does not come
into contact with water�
4� Clean the device as described
under "7� Cleaning and main-
tenance"�
What to do if the device tips over during use
If the device should tip over during use, then water may enter the ventilation open-
ing� In the event of this, there is a water drainage hole on the underneath of the
device so that the water can drain out of the ventilation opening� To drain the water
from the water drainage hole, proceed as follows:
1� Remove the mains adapter from the mains socket�
2� Empty the water tank with the ventilation opening at the top so that no water
can enter the ventilation opening�
3� Tip the device in the direction of the water drainage hole so that the water can
drain�
Ventilation opening
4� Allow the device to dry for at least 24 hours�
Ventilation opening at top
Water drainage hole
26