Introduction; Features; Basic Setup; Getting Started - Phonic POWERPOD 1460 Manual Del Usuario

INTRODUCTION

Phonic would like to congratulate you on the purchase
of the Powerpod 1460, a powered mixer that provides
more than the average. Since its introduction, the entire
Powerpod range has given other powered mixer lines a
run for their money. With fantastically low noise levels,
high signal handling abilities, exceptional output levels,
simplified signal routing abilities, and ultra-smooth controls,
the Powerod 1460 provides a level of dependability not
often found in powered mixers as of late.
We know how eager you are to get started – getting the
mixer out and hooking all your gear up is probably your
number one priority right now – but before you do, we
strongly urge you to take a look through this manual.
Inside, you will find important facts and figures on the set
up, use and applications of your brand new mixer. If you
do happen to be one of the many people who flatly refuse
to read user manuals, then we just urge you to at least
glance at the Instant Setup section. After glancing at or
reading through the manual (we applaud you if you do
read the entire manual), please store it in a place that
is easy for you to find, because chances are there's
something you missed the first time around.

FEATURES

• 2 x 300 Watt / 4Ω power amplifier, bridgeable and patchable
• 4 mic preamp in total
• 4 Mic /Line input and 4 line channels with 3-band EQ
• 2 stereo input channels with 3-band EQ,
• 2 stereo returns
• Stereo 8-band graphic EQ
• Effect processor with 100+ effects and level control
• +48V global phantom power switches
• Mono output
• PFL on each input and AFL on each output
• Headphone with control room output rotary level control
• 1/4" phone jacks and bridge out for speaker connection
• Rugged metal main chassis with integrated handle
POWERPOD 1460

BASIC SETUP

Getting started

1. Ensure all power is turned off on the Powerpod
1460 Powered Mixer. To totally ensure this, the
AC cable should not be connected to the unit.
2. All faders and level controls should be set at the
lowest level to ensure no sound is inadvertently
sent through the outputs when the device is
switched on. All levels should be altered to
acceptable degrees after the device is turned
on.
NB. Ensure that the rear of the mixer is not less than 30
centimeters from the wall, as being closer than that may obstruct
the cooling fans and cause overheating.
3. Plug all necessary instruments and equipment
into the device's various inputs as required.
This may include line signal devices, as well as
microphones and/or guitars, keyboards, etc.
4. Plug any necessary equipment into the device's
various outputs. This could include speakers,
monitors, signal processors, and/or recording
devices.
NB. No devices other than speakers should be connected to
the power amp outputs. Plugging inappropriate devices into the
mixer will likely cause damage to the device. Also, guitar cables
should not be used to connect amplifiers to speakers.
5. Plug the supplied AC cable into the AC inlet on
the back of the device ensure the local voltage
level is identical to that required on your device.
6. Plug the supplied AC cable into a power outlet of
a suitable voltage.
7. Turn the power switch on.
1