Kreg KPCS Manual Del Propietário página 5

Small Guide
Use the small guide for the Plug Cutting Bit and optional Plug Cutting
Bit-Micro. Use the large guide for the optional Plug Cutting Bit-HD.
3 Set your drill to the highest speed. Slide the bit into the cutter guide
until it contacts the plug blank, then withdraw it about ¼" [6mm].
Start the drill and let it come to full speed. Using light pressure and a
slow feed rate, start cutting the plug.
ATTENTION
the thin tip section of the plug. At this stage, let the weight of
the drill control the feed rate. As you drill deeper and resistance
increases, apply very slight additional pressure.
WARNING
bit to cool before handling.
4 As the bit engages more of the plug blank, increase drilling pressure
and continue drilling until the stop collar contacts the guide block.
5 To make additional plugs, reposition the plug blank and repeat
Steps 2-4.
Drill the plugs
You will feel little resistance at first as the bit cuts
The drill bit gets hot when drilling plugs. Allow the
Large Guide