Output Channels; Mac Operation - Phonic FIREFLY 302 USB Manual Del Usuario

Output Channels

by entering the output channels section, users
can view and edit the names of the two analog
output channels and two S/Pdif output channels
that are sent from the computer to the Firefly.
Driver Information
this section allows users to check the version
of their currently used driver and the interface.
new drivers will be made available from time to
time on the Phonic document center, and an an-
nouncement will usually be made on the Phonic
home page.
14

MAC OPERATION

After installing the Firefly 302 USB driver and
software to your Mac computer, enter the audio
Midi Setup application and you should be able to
select the Phonic Firefly 302 USB as your default
input and output device.
also in the audio Midi Setup, you will be able to
adjust volume levels of your various input and
output signals, as well as the sampling rate and
resolution you want to use. Users are able to se-
lect between 44.1, 48, 88.2, 96, 176.4 and 192
kHz sampling rates. resolution can be selected
between 24-bit, 20-bit and 16-bit. Both the sam-
pling rate and resolution can be adjusted in your
daW software as well (depending on what soft-
ware you use).
also in the audio Midi Setup, tracks can be mut-
ed at will, and input signals can be set to 'thru',
which - put simply - will return the input signals
directly back to their corresponding outputs.
the input and output channel names listed corre-
spond with each of the Firefly's input and outputs.
Channels 1 to 6 on the input correspond, in order,
with analog inputs 1 and 2 (listed in the audio
Midi Setup as channels 1 and 2), the microphone
input (channels 3 and 4) and the S/Pdif left and
right input signals (channels 5 and 6). The output
channels 1 to 4 are, in order, analog outputs 1
and 2 and S/Pdif outputs left and right.
Firefly 302 USB