CONFIGURATION
QNUBU
-Set Temperature:
Press Set button 1x time,Screen show "SH" and PV side number blinking, the
temp can now be set using the
-Set Compression Time:
Press Set button 2x time,screen show "SE"the time can now be set
using the
-Confirm setting: After finish setting of time and temperature you should
press set once again to confirm the your setting, screen will exit setting
mode and start heating.
-Countdown: After platen closed, press
down press time.
PRESSURE ADJUSTMENT:
Clockwise: Increase pressure Counterclockwise: Reducing pressure.
TEMPERATURE & TIME SETTING:
Set button
to increase or decrease time.
Every press Pressure is set well. If you still need to
increase or decrease pressure, please adjust by the
screw before setting a temperature.
Increase button/
countdown button
to increase or decrease temperature.
"TIME" start Counting
¡DONT FORCE THE PRESS!
IF YOU TRY TO APPLY OVER-PRESSURE
THE PRODUCT WILL BE DAMAGED
Decrease
button
TIP