Logic3 LG290 Manual Del Usuario página 3

User Manual
Setup/Pairing of PowerPoint/Keynote Remote Control
1. Remove the Remote Control from the Holder.
2. Remove the USB Receiver from the back of the Remote Control.
Open the battery lid and put in the battery, replace battery lid.
WARNING: Please ensure that the battery is inserted correctly. If the battery is inserted
incorrectly (reversed polarity), this may cause personal injury as well as damage to your
PowerPoint/Keynote Remote Control
3. Plug the USB Receiver into the USB port of your Note Book.
4. Press the ID Link button on the USB Receiver (Link Indicator will light up).
5. Press and hold the FN and Link button on the remote control until the Link Indicator on the Receiver
starts to blink, this will indicate pairing is successful.
For MAC OS.X. Please follow the below steps (Only to be performed the first time the remote
is used):-
1 When you first plug-in the Receiver, the Mac OS X keyboard pairing window will be displayed
on screen.
2 Follow Pairing as explained in Setup/Pairing of PowerPoint/Keynote Remote Control
3 Click 'Continue' on the Keyboard Setup Assistant.
Note : PowerPoint/Keynote Remote Control is designed to be seen by your system as a
keyboard to enable you to use it without installing additional software drivers (re-spin this as
needed).
English
2