Warranty Provisions And Disclaimer; Obligations Of The Operator; Licence Conditions; Explanation Of Listed Symbols - BWT PERMAQ compact 2 Instrucciones De Montaje

EN

1.4.2 Warranty provisions and disclaimer

Please observe: All of the information and instructions
contained in this installation and operating manual were
provided in respect of current standards, regulations,
prior art and our long term experiences.
BWT excludes any responsibility for damages and
for consequential loss due to:
initial operation and operation, maintenance
work
manipulation

1.4.3 Obligations of the operator

close to and accessible at the RO unit.
manner and if the safety status is reliable.
operating manual have to be followed properly.

1.4.4 Licence conditions

The IOM is protected by copyright. Surrendering the manual
to any third party, duplication of any kind and form – also in
excerpts – as well as the utilisation and/or communication of
the content are not permitted without the written consent of the
manufacturer. Infringements obligate to pay compensation for
damages. Further claims are reserved.
Note: Upon the acquisition of the reverse osmosis, the user recei-
ves an exclusive, non-transferrable right of utilisation in respect
of the software installed by the manufacturer.

1.4.5 Explanation of listed symbols

This installation and operating manual uses warnings/symbols!
The warnings/instructions are introduced by signal words to
underline risks.
Please follow instructions and treat them with maximum importance
to avoid any accidents and damages.
Danger: Caused by electric current or voltage!
Always consult a qualified electrician when working
on places denoted by this symbol.
Attention: Dangerous spot!
Details or orders and prohibitions to avoid personal
injury or extensive damage to property.
30
Please observe: Underlines useful recommendations
and information for an efficient operation free of any
interruptions.
Note: Additional information for the operator.

1.5 Operation and safety precaution advices

The following chapter provides an overview of all important
operation and safety precaution advices to enable safe operation
free of any interruptions. Despite all safety precaution measures,
residual risks still remain, particularly in case of improper use and
handling. A warranty claim will be denied, if the notices and ad-
vices of this installation and operating manual are not respected.

1.5.1 Intended use of device

The device is suitable for the desalination of water in drinking
water quality up to max. 30°C and a raw water pressure of
max. 4.0bar and can be operated either directly in front of the
consumer or additionally it is possible to install an atmospheric
pressure tank downstream, to improve peak situations of the user
required permeate demands.
ATTENTION: in the pressure tank operation, should be
the corresponding flow loss to be considered (see table).
Observe: The feed water quality has to meet the requi-
rements of the technical specifications and the limit
value of the solubility of lime (see Part 6.1) and must
not be exceeded! The pump pressure must not exceed
8.6bar (max. permissible value) and should therefore be
readjusted if necessary!
The device shall only be used for its intended purpose, in line with
the installation and operating manual and in the environment to
which it was intended and designed. Deviations are regarded
as "non-intended purpose".
The intended use also comprises the adherence to the operating,
maintenance and upkeep conditions stipulated by the manufacturer.
Attention: The RO unit must be fed with cold water in
drinking water quality.
Every deviation from the intended purpose, e.g. deionisation of
feed water of non-drinking water quality, can led to irreversible
damages or can cause undesired microbial contamination of
the unit.

1.5.2 Permitted mode of operation

Observe: To protect the drinking water, observe
the country-specific guidelines for drinking water
installations in any work at the RO device.
system, the device must be separated from the water supply
system. Rinse the water pipe sufficiently before reconnecting
the device.
equipment prior to assembly (unplug mains plug).