Urmet 2Voice 1083 Guia De Inicio Rapido página 10

Interfaz de habitación pstn
Ocultar thumbs Ver también para 2Voice 1083:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

In apartments, up to 4 apartment stations in parallel with the same user code and different internal codes
can be connected.
The internal code identifies each station of the same user. This means that intercom calls can be addressed
to the single internal code in the same apartment.
In case of intercom calls to different apartments, in case of calls coming from door units and in case of floor
call, all the user apartment stations always ring. Consider also that, after receiving a call, the internal code
0 rings immediately; the internal codes 1,  and 3 ring in sequence.
FEATURES AVAILABLE IN APARTMENT STATION MODE
RECEIVING CALLS IN APARTMENT STATION MODE
After receiving a call, the telephones connected on au, bu ring for 60 seconds max. (off-hook waiting
time).
By picking the handset up, a communication is established with the caller.
VIDEO SIGNAL IN APARTMENT STATION MODE
When a video door phone call is received, on all the interfaces of the called apartment, the video signal is
available on the terminal pins V3-V5 and the video voltages are present on the terminal pins RD and ONV
(referred to V5). The video signal and the above mentioned voltages are active until the call is terminated.
DOOR OPENING IN APARTMENT STATION MODE
To send a pedestrian door lock release command, pick the handset up and enter  or 333 to open the
gate (for details, see the chapter "DTMF codes").
AUTO-ON FUNCTION IN APARTMENT STATION MODE
If the interface is in standby, the auto-on function can be performed on the door units: pick the handset
up and send the command 888. By sending again the same command, it is possible to cyclically display
the images coming from the control cameras, from the cameras of the system main door units and from
secondary door units of the same column.
By sending the command 880, an audio and video communication is established with the selected door
unit. The user can open at any time the door of the selected door unit with the command  (pedestrian)
or 333 (gate).
By hanging the handset up, the auto-on function is closed.
INTERCOM CALL FORWARDING IN APARTMENT STATION MODE
Pick the handset up and send the chosen command (see the chapter "DTMF codes").
The following cases can occur:
Apartment station free: the called apartment station rings. When the handset is picked up, the
communication is established.
Apartment station busy: the phone emits an alert tone (4 fast beeps). Hang up and try again later.
FLOOR CALL FUNCTION IN APARTMENT STATION MODE
The interface is provided with two terminal pins (CP) for the connection of the floor call button. When the
button is pressed, the telephones ring for 60 seconds max. If the user has several apartment stations in
parallel, connect this button only on an apartment station or an interface. The apartment stations will ring
in sequence.
ADDITIONAL RINGER IN APARTMENT STATION MODE
The interfaces are provided with two terminal pins (S+, S-), used to connect an additional ringer or a relay or
10
DS1083-01A

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

1083/67

Tabla de contenido