Important; Features; Technical Data - Surtek MT514A Manual De Usuario

• Do not touch the workpiece immediately after
operation. It may be extremely hot, and could
burn the skin.
• Regularly clean the tool's air vents with com-
pressed air. Excessive accumulation of powdered
metal inside the motor housing may cause elec-
trical failures.
• Do not alter or misuse tool. Any alteration or
modification is a misuse and may result in seri-
ous personal injury.
IMPORTANT: This product is not intended
for use as a dental drill, in human or veterinary
medical applications.
WARNING: Some dust created by power
sanding, sawing, grinding, drilling, and other
construction activities, contain chemicals known
to cause cancer, birth defects or other reproduc-
tive harm.
Some examples of these chemicals are:
• Lead from lead-based paints.
• Crystalline silica from bricks and cement or
other masonry products.
• Arsenic and chromium from chemically treated
lumber.
Your risk from these exposures varies, depend-
ing on how often you do this type of work. We
recommend you work in a well ventilated area,
and work with approved safety equipment, such
as those dust masks that are specially designed
to filter out microscopic particles. Work in well
ventilated areas.

FEATURES

The moto tool incorporates both highspeed
and performance to serve as a carver, grinder,
polisher, sander, cutter, power brush, drill, and
more. The tool use a small, but effective motor.
The large variety of available accessories in-
cludes abrasive wheels, drill bits, wire and nylon
brushes, engraving and carving cutters, router
bits, polishing points and more.
KNOW YOUR TOOL
5
4
3
2
1
7
6
8
9
E N G L I S H •
1. COLLET NUT.
2. COLLET.
3. HOUSING CAP.
4. SHAFT LOCK BUTTON.
5. CARBON BRUSH COVER (BOTH SIDES).
6. ELECTRIC SPEED SELECTOR.
7. ON/OFF BUTTON.
8. HANGER.
9. VENTILATION OPENINGS.

TECHNICAL DATA

MT514A
VOLTAGE-FRECUENCY
MAXIMUM COLLET CAPACITY
NO LOAD SPEED
POWER
WEIGHT (COMPLETE SET)
INSTALLING COLLETS AND ACCESSORIES
WARNING: Always unplug mototool before
changing accessories, changing collets, or servic-
ing.
CAUTION: Always use the collet which match-
es the shank size of the accessory you plan to
use. Do not force a larger diameter shank into
a smaller collet.
CHANGING COLLETS
1. Press the shaft lock
button, hold down and
rotate the shaft by hand
until it press the shaft.
2. With the shaft lock button pressed, loosen
and remove the collet nut. Use the collet wrench
if necessary.
3. Remove the collet by pulling it free from the
shaft.
4. Install the appropriate size collet fully into the
shaft and reinstall the collet nut finger tight. Do
not fully tighten the nut when there is no bit or
accessory installed.
CHANGING ACCESSORIES
1. Press and hold the shaft lock button. Do not
press the shaft lock button while moto tool is
running.
2. With the shaft lock but-
ton pressed, loosen (do
not remove) the collet
nut. Use the collet wrench
if necessary.
3. Insert the bit or acces-
sory shank fully into the
collet.
4. With the shaft lock button pressed, finger
Us er 's M an u a l
120 V ~ 60 Hz
1/8" (3,1 mm)
9 000 - 32 000 r/min
160 W
7,5 kg (16,5 lb)
Tighten
Loosen
11